Flatop Series Application Guide

Please complete and submit this questionnaire, or contact your local Flo-Turn distributor or the factory for prompt evaluation of your proposed application

Name:		Title:
Company:		Email:
City:		State:		Zip:
Telephone:		FAX:

The illustration at right represents a typical 90º power turn installation with relation to adjoining conveyors noted as "IN" and "OUT." Regardless of turn degree required, the basic necessary information would be the same. The drive shown is only to demonstrate optional locations. Please answer the portion of this questionnaire relative to your proposed or present system. Indicate the relative belt and conveyor frame widths in the spaces provided in the plan drawing to the right.

Note: For best product transfer we recommend O.A.W. of mating conveyor to be equal or less than turn belt width.

BELT SPEEDS (Feet per minute):	"IN" conv.	ft./min.	"OUT" conv.	ft./min.
BELT HEIGHTS ABOVE FLOOR:	"IN" conv.	inches	"OUT" conv.	inches
With reference to "C' in illustration, give degree of turns required:				degrees
A "RIGHT" turn is shown. With relation to your flow of material and direction of conveyors, do you need			"RIGHT"	"LEFT"
What type of belt is on the present conveyors or needed for special conditions
Is system to be reversible?		Yes	or	No
Is drive location on . . .		Inside Radius "A"	or	Outside Radius "B"
Would unit be . . .		floor supported	or	ceiling hung
Will side-guards be required: .		Yes If "Yes", give height of top above belt inches	or	No
ELECTRICAL CHARACTERISTICS (If drive would be furnished)		Voltage	Phase	Hertz
Other information you feel might be helpful